Not included Brush compressed air blade 
Clean backstrap area with a clean nylon brush An old toothbrush will do DO NOT use a brush that has been in contact with oil based solvents 
Gently clean with provided cleaning pad 
Blow remaining residue off with compressed air Blow on it if need be but dont spit on it 
Check position before removing tape You wont be able to install completely but can see the alignment 
Remove tape carefully starting at a corner with a razor blade 
Align ejector housing pin cutout with the bottom of the notch for the cutout on the backstrap Press one side forward until seated 
Press the other side forward until seated 
Very firmly grip the gun for 30 seconds Wait at least 24 hours before use to let the adhesive set 
To remove apply firm pressure using the notch cut into the Backstrap as a grip point Push towards the opposite side of the gun The adhesive sticks quite well you may need to wear gloves with some grip Slowly keep pushing to the side until removed
Thru end of day 12/1/26
All products - most everything is in stock
2 weeks ago